News and Events

​The flash butt welding machine can effectively remove impurities and iron oxide at the joint, and the welding quality is stronger than that of the resistance welding machine. The welding excuse of the flash welding machine is relatively strong.

​The polyethylene butt welder uses two ways to connect PE pipes. Hot melt connection and electrofusion connection. At present, the main pipeline is mainly connected by hot melt. The principle of hot-melt connection is to close the mating surfaces of two PE pipes to a heating tool to heat their flat end surfaces until they melt. After removing the heating tool, put the two molten end surfaces close together and keep them under pressure. Cool down to the joint to make it a whole.

​The hdpe jointing machine, this kind of machine is processed by hot-melt glue to join two pieces of veneer into one veneer. This kind of machine requires high precision. The thickness deviation of the veneer should not be too large, otherwise it will not be good! A lot of attention should be paid to the smoother wood. Thickness, the thickness between pieces, etc.; the splicing length is 3M.

​Full automatic butt fusion machine is a machine that uses ultrasonic energy to weld (or secondary connection) plastic electronics, toys, stationery and daily medical articles. It melts the contact surface of two raw materials through local high temperature, and then fuses and solidifies together under certain pressure. Automatic butt fusion machine is widely used because of its high working efficiency, good quality, energy saving and environmental protection.